ADTRAN AOS Version R10.1.0 Command Reference Manual page 120

Command Reference Guide
clear ip ffe
Use the clear ip ffe command to remove the RapidRoute Engine entries on all interfaces or on a specific
interface. Variations of this command include:
clear ip ffe <interface>
clear ip ffe ipsec
clear ip ffe ipsec <rapidroute interface ID>
Syntax Description
<interface>
ipsec
<rapidroute interface ID>
Default Values
No default values are necessary for this command.
Command History
Release 13.1
Release 17.6
Release A4.01
Release A5.01
Usage Examples
The following example clears all RapidRoute entries for the Ethernet 0/1 interface:
>enable
#clear ip ffe ethernet 0/1
60000CRG0-35E
Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1. Type clear ip ffe? for a complete list of valid interfaces.
Specifies that all RapidRoute entries to and from an Internet Protocol
security (IPsec) security association (SA) are cleared.
Specifies that RapidRoute entries to and from an IPsec SA on a specified
RapidRoute interface are cleared. RapidRoute interface identifiers range
from 1 to 16777215.
Command was introduced.
Command was expanded to include ipsec parameters.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
120