Clear Ip Igmp Group - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

clear ip igmp group

Use the clear ip igmp group command to clear entries from the Internet Group Management Protocol
(IGMP) tables. If no address or interface is specified, all nonstatic IGMP groups are cleared with this
command. Variations of this command include:
clear ip igmp group
clear ip igmp group <multicast address>
clear ip igmp group <interface>
Syntax Description
<multicast address>
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 7.1
Release 9.1
Release A4.01
Release A5.01
Usage Examples
The following example clears all statistics from the IGMP tables for all nonstatic IGMP groups:
>enable
#clear ip igmp group
60000CRG0-35E
Optional. Clears the IGMP tables of a specific multicast group IP address. The
multicast group IP address range is 244.0.0.0 to 239.255.255.255 or
224.0.0.0 /4.
Optional. Clears the IGMP tables of all interfaces of the specified type or a
specific interface of a particular type. Specify an interface in the format
<interface type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for a T1
interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a PPP
interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type clear ip igmp group
? for a list of valid interfaces.
Command was introduced.
Command was expanded to include the high-bit-rate digital subscriber line
(HDSL) and tunnel interfaces.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
123