ADTRAN AOS Version R10.1.0 Command Reference Manual page 125

Command Reference Guide
clear ip policy-sessions
Use the clear ip policy-sessions command to clear Internet Protocol version 4 (IPv4) access control policy
(ACP) firewall sessions. You may clear all the IPv4 sessions or a specific session. Use the show ip
policy-sessions command to view a current IPv4 session listing. Variations of this command include:
clear ip policy-sessions
clear ip policy-sessions any-vrf
clear ip policy-sessions pending
clear ip policy-sessions <ipv4 acp name> [ahp | esp | gre | icmp | tcp | udp | <protocol>] <ipv4 source>
<source port> <ipv4 destination> <destination port>
clear ip policy-sessions <ipv4 acp name> [ahp | esp | gre | icmp | tcp | udp | <protocol>] <ipv4 source>
<source port> <ipv4 destination> <destination port> [destination | source] <nat ipv4 address>
<nat address port>
clear ip policy-sessions vrf <name>
clear ip policy-sessions vrf <name> <ipv4 acp name> [ahp | esp | gre | icmp | tcp | udp | <protocol>]
<ipv4 source> <source port> <ipv4 destination> <destination port>
clear ip policy-sessions vrf <name> <ipv4 acp name> [ahp | esp | gre | icmp | tcp | udp | <protocol>]
<ipv4 source> <source port> <ipv4 destination> <destination port> [destination | source]
<nat ipv4 address> <nat port>
Syntax Description
any-vrf
pending
<ipv4 acp name>
ahp
esp
gre
icmp
tcp
udp
<protocol>
<ipv4 source>
<source port>
<ipv4 destination>
<destination port>
[destination | source]
60000CRG0-35E
Optional. Clears the current ACP associations for all VPN routing and
forwarding (VRF) instances.
Optional. Clears pending ACP associations that are waiting on unknown
traffic.
Specifies the IPv4 ACP from which to clear the firewall sessions.
Specifies Authentication Header (AH) Protocol.
Specifies Encapsulating Security Payload (ESP) Protocol.
Specifies Generic Routing Encapsulation (GRE) Protocol.
Specifies Internet Control Message Protocol (ICMP).
Specifies Transmission Control Protocol (TCP).
Specifies User Datagram Protocol (UDP).
Specifies a protocol. Valid range is 0 to 255.
Specifies the source IPv4 address. IPv4 addresses should be expressed in
dotted decimal notation (for example, 10.10.10.1).
Specifies the source port (in hex format AH, ESP, and GRE; decimal for all
other protocols).
Specifies the destination IPv4 address. IPv4 addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Specifies the destination port (in hex format for AH, ESP, and GRE; decimal
for all other protocols).
For network address translation (NAT) sessions, this specifies whether to
select a NAT source or NAT destination session.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
125