ADTRAN AOS Version R10.1.0 Command Reference Manual page 160

Command Reference Guide
clear pppoe <interface>
Use the clear pppoe command to terminate the current Point-to-Point Protocol over Ethernet (PPPoE)
client session and cause AOS to attempt to re-establish the session.
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Usage Examples
The following example ends the current PPPoE client session for ppp 1:
>enable
#clear pppoe 1
60000CRG0-35E
Specifies the Point-to-Point Protocol (PPP) interface ID number to clear.
Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type clear pppoe ? for a complete list of valid interfaces.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
160