ADTRAN AOS Version R10.1.0 Command Reference Manual page 172

Command Reference Guide
clear spanning-tree counters
The clear spanning-tree counters command clears the following counts: bridge protocol data unit
(BPDU) transmit, BPDU receive, and number of transitions to forwarding state. Variations of this
command include:
clear spanning-tree counters
clear spanning-tree counters interface <interface>
Syntax Description
interface <interface>
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Release A4.01
Usage Examples
The following example clears the spanning tree counters for Ethernet 0/10:
>enable
#clear spanning-tree counters interface eth 0/10
60000CRG0-35E
Optional. Specifies a single interface. Specify an interface in the format
<interface type [slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for a T1
interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a PPP
interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type clear spanning-tree
counters ? for a complete list of interfaces.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
172