Dtc Module Start Register (Dtcst) - Renesas RX100 Series User Manual

RX13T Group
16.2.11

DTC Module Start Register (DTCST)

Address(es): DTC.DTCST 0008 240Ch
b7 b6
— —
Value after reset: 0 0
Bit Symbol Bit Name
b0 DTCST DTC Module Start
b7 to b1 — Reserved
DTCST Bit (DTC Module Start)
Set the DTCST bit to 1 to enable the DTC to accept transfer requests. When this bit is set to 0, transfer requests are no
longer accepted.
If this bit is set to 0 during data transfer, the accepted transfer request is active until the processing is completed.
Set the DTCST bit to 0 before making a transition to the module stop state, deep sleep mode, or software standby mode.
Set the DTCST bit to 1 to resume the data transfer after returning from the module stop state, deep sleep mode, or
software standby mode.
For details on transitions to the module stop state, deep sleep mode, and software standby mode, refer to section 16.8,
Low Power Consumption Function , and section 11, Low Power Consumption .
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
b5 b4 b3 b2
— — — —
0 0 0 0
b1 b0
— DTCST
0 0
Description
0: DTC module stop
1: DTC module start
These bits are read as 0. The write value should be 0.
16. Data Transfer Controller (DTCb)
Page 256 of 1041
R/W
R/W
R/W