Renesas RX100 Series User Manual page 830

RX13T Group
Table 26.8 Selection of A/D Activation Sources by the TRSC[5:0] Bits
Module Source
Trigger source deselection state
MTU TRGA0N
TRGA1N
TRGA2N
TRGA3N
TRGA4N
TRG0N
TRG4AN
TRG4BN
TRG4AN or
TRG4BN
TRG4ABN
GCADIE Bit (Group C Scan End Interrupt Enable)
This bit enables or disables scan end interrupt generation for group C.
GRCE Bit (Group C A/D Conversion Operation Enable)
When using group C in group scan mode, set the GRCE bit to 1.
When the GRCE bit is 0, trigger input for group C is disabled.
During group priority operation (the ADGSPCR.PGS bit is 1) with group C used, when the ADGSPCR.GBRP bit is set
to 1, single scan for group C is continuously operated. When the GRCE bit is set to 1, single scan for group B is not
continuously operated.
The GRCE bit should be set while the ADCSR.ADST bit is 0.
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
Remarks
Compare match/input capture from MTU0.TGRA
Compare match/input capture from MTU1.TGRA
Compare match/input capture from MTU2.TGRA
Compare match/input capture from MTU3.TGRA
Compare match/input capture from MTU4.TGRA or underflow
(trough) of MTU4.TCNT in complementary PWM mode
Compare match from MTU0.TGRE
Compare match between MTU4.TADCORA and MTU4.TCNT
Compare match between MTU4.TADCORB and MTU4.TCNT
Compare match between MTU4.TADCORA and MTU4.TCNT, or
compare match between MTU4.TADCORB and MTU4.TCNT
Compare match between MTU4.TADCORA and MTU4.TCNT,
and compare match between MTU4.TADCORB and
MTU4.TCNT (when interrupt skipping function 2 is used)
26. 12-Bit A/D Converter (S12ADF)
TRSC[5] TRSC[4] TRSC[3] TRSC[2] TRSC[1] TRSC[0]
1 1 1 1
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 1
0 0 0 1
0 0 1 0
0 0 1 0
0 0 1 0
0 0 1 0
0 0 1 1
Page 830 of 1041
1 1
0 1
1 0
1 1
0 0
0 1
0 0
0 1
1 0
1 1
0 0