Renesas RX100 Series User Manual page 857

RX13T Group
Table 26.12 Group Priority Operation Setting and Operating Mode for Three Groups
(ADGSPCR.PGS = 1, ADGCTRGR.GRCE = 1)
ADGSPCR
GBRSCN LGRRS GBRP
0 x 0
0 x 1
1 0 0
1 1 0
1 0 1
1 1 1
x = Don't care
Note 1. When self-diagnosis is used (ADCER.DIAGM = 1), A/D conversion of the discontinued channel is started after self-diagnosis.
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
Operation
Group priority operation for three groups (groups A, B, and C)
 When a group A trigger is input, group B scan is completed (not restarted)
 When a trigger for group A or B is input, group C scan is not completed (not restarted).
Group priority operation for three groups (groups A, B, and C)
 When a group A trigger is input, group B scan is completed (not restarted)
 Single scan for group C is started continuously without start trigger input. After group C scan is
discontinued, scan is restarted from the head of the channel selected with the ADANSC0
register after scan for groups A and B is completed.
Group priority operation for three groups (groups A, B, and C)
 After group B scan is discontinued, scan is restarted from the head of the channel selected
with the ADANSB0 register after group A scan is completed.
 After group C scan is discontinued, scan is restarted from the head of the channel selected
with the ADANSC0 register after scan for groups A and B is completed.
Group priority operation for three groups (groups A, B, and C)
 After group B scan is discontinued, scan is restarted from the head of the channel selected
with the ADANSB0 register after group A scan is completed.
 After group C scan is discontinued, scan is restarted from the channel on which scan was
1
discontinued* , among the channels selected with the ADANSC0 register after scan for
groups A and B is completed.
Group priority operation for three groups (groups A, B, and C)
 After group B scan is discontinued, scan is restarted from the head of the channel selected
with the ADANSB0 register after group A scan is completed.
 Single scan for group C is started continuously without start trigger input. After group C scan is
discontinued, single scan is restarted from the head of the channel selected with the
ADANSC0 register after scan for groups A and B is completed.
Group priority operation for three groups (groups A, B, and C)
 After scanning for group B is discontinued, once scanning for group A completes, scanning is
resumed starting from the channel on which scanning was discontinued*
channels selected with the ADANSB0 register.
 Single scan for group C is started continuously without start trigger input. After group C scan is
discontinued, single scan is restarted from the channel on which scan was discontinued*
among the channels selected with the ADANSC0 register after scan for groups A and B is
completed.
26. 12-Bit A/D Converter (S12ADF)
1
, among those
Page 857 of 1041
1
,