Transfer Information Read Skip Function - Renesas RX100 Series User Manual

RX13T Group
Table 16.4 Chain Transfer Conditions
First Transfer
CHNE CHNS DISEL
Bit Bit Bit
0 — 0
0 — 0
0 — 1
1 0 —
1 1 0
1 1 —
1 1 1
Note 1. The transfer counters used depend on transfer modes as follows:
Normal transfer mode: CRA register
Repeat transfer mode: CRAL register
Block transfer mode: CRB register
Note 2. On completion of data transfer, the counters operate as follows:
1 → 0 in normal and block transfer modes
1 → CRAH in repeat transfer mode
(1 →  ) in the table indicates both of the two operations above.
Note 3. Chain transfer can be selected for the second or subsequent transfers. The condition combination of "second transfer and the
CHNE bit is 1" is omitted.
16.4.1

Transfer Information Read Skip Function

Reading of DTC vector and transfer information can be skipped by the setting of the DTCCR.RRS bit.
When a DTC transfer request is accepted, the current DTC vector number is compared with the DTC vector number in
the previous data transfer. When these vector numbers match and the RRS bit is 1, the DTC does not read the DTC vector
and transfer information, and transfers data according to the transfer information remained in the DTC.
However, when the previous transfer was chain transfer, the DTC vector and transfer information are read. Furthermore,
when the transfer counter (CRA register) became 0 during the previous normal transfer and when the transfer counter
(CRB register) became 0 during the previous block transfer, transfer information is read regardless of the value of the
RRS bit. Figure 16.14 shows an example of transfer information read skip.
When updating the vector table and transfer information, set the RRS bit to 0, update the vector table and transfer
information, and then set the RRS bit to 1. Setting the RRS bit to 0 discards the vector numbers retained in the DTC. The
updated DTC vector table and transfer information are read in the next data transfer.
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
Transfer CHNE
Counter* 1, * 2 Bit
Other than (1 → 0) —
(1 → 0) —
— —
— 0
0
0
Other than (1 →  )
—
(1 →  )
0
0
0
Other than (1 →  )
—
16. Data Transfer Controller (DTCb)
3
Second Transfer*
CHNS DISEL Transfer
Bit Bit Counter*
— — —
— — —
— — —
— 0 Other than (1 → 0)
— 0 (1 → 0)
— 1 —
— — —
— 0 Other than (1 → 0)
— 0 (1 → 0)
— 1 —
— — —
1, * 2 Data Transfer
Ends after the first
transfer
Ends after the first
transfer with an interrupt
request to the CPU
Ends after the second
transfer
Ends after the second
transfer with an interrupt
request to the CPU
Ends after the first
transfer
Ends after the second
transfer
Ends after the second
transfer with an interrupt
request to the CPU
Ends after the first
transfer with an interrupt
request to the CPU
Page 265 of 1041