RX13T Group
16.9.3
Notes on Using the Sequence Transfer
When sequence transfer is to be used, make sure that the DTCADMOD.SHORT bit is 0 (full-address mode) and the
DTCCR.RRS bit is also 0 (transfer information read is not skipped).
In addition, set the MRB.CHNE bit to 0 (chain transfer is disabled) when setting the MRB.INDX bit to 1 (start sequence
transfer and refer the index table) or the MRB.SQEND bit to 1 (end the sequence transfer).
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
16. Data Transfer Controller (DTCb)
Page 292 of 1041