Voltage Monitoring Circuit Control Register (Lvcmpcr) - Renesas RX100 Series User Manual

RX13T Group
8.2.5

Voltage Monitoring Circuit Control Register (LVCMPCR)

Address(es): 0008 C297h
b7 b6
— LVD2E LVD1E
0 0
Value after reset:
Bit Symbol
b4 to b0 —
b5 LVD1E
b6 LVD2E
b7 —
Note: Set the PRCR.PRC3 bit to 1 (write enabled) before rewriting this register.
LVD1E Bit (Voltage Detection 1 Enable)
When using voltage detection 1 interrupt/reset or the LVD1SR.LVD1MON flag, set the LVD1E bit to 1. The voltage
detection 1 circuit starts once Td
LVD2E Bit (Voltage Detection 2 Enable)
When using voltage detection 2 interrupt/reset or the LVD2SR.LVD2MON flag, set the LVD2E bit to 1. The voltage
detection 2 circuit starts once Td
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
b5 b4 b3 b2
— — —
0 0 0 0
Bit Name
Reserved
Voltage Detection 1 Enable
Voltage Detection 2 Enable
Reserved
passes after the LVD1E bit value is changed from 0 to 1.
(E-A)
passes after the LVD2E bit value is changed from 0 to 1.
(E-A)
b1 b0
— —
0 0
Description
These bits are read as 0. The write value should be 0.
0: Voltage detection 1 circuit disabled
1: Voltage detection 1 circuit enabled
0: Voltage detection 2 circuit disabled
1: Voltage detection 2 circuit enabled
This bit is read as 0. The write value should be 0.
8. Voltage Detection Circuit (LVDAb)
Page 119 of 1041
R/W
R/W
R/W
R/W
R/W