Timer Prescaler Register (Tpre); Timer Count Register (Tcnt) - Renesas RX100 Series User Manual

32-bit mcu
Hide thumbs Also See for RX100 Series:
Table of Contents

Advertisement

RX13T Group
23.2.38

Timer Prescaler Register (TPRE)

Address(es): SCI12.TPRE 0008 B332h
b7
b6
Value after reset:
1
1
TPRE consists of an 8-bit reload register, a read buffer, and a counter, each of which has FFh as its initial value. The
counter counts down in synchronization with the counter clock selected by the TMR.TCSS[2:0] bits, and is reloaded with
the value in the reload register when it underflows. Underflows of this register provide the clock source to drive counting
by the TCNT register. The reload register and read buffer are allocated to the same address. Data is written to the reload
register in writing, and the counter value that has been transferred to the read buffer is returned in reading.
It takes one PCLK cycle to load a value from the reload register to the counter.
23.2.39

Timer Count Register (TCNT)

Address(es): SCI12.TCNT 0008 B333h
b7
b6
Value after reset:
1
1
TCNT consists of an 8-bit reload register, a read buffer, and a counter, each of which has FFh as its initial value. This
down-counter counts underflows of the TPRE register until the TCNT register underflows, and is then reloaded with the
value from the reload register. The reload register and read buffer are allocated to the same address. Data is written to the
reload register in writing, and the counter value that has been transferred to the read buffer is returned in reading.
It takes one PCLK cycle to load a value from the reload register to the counter.
R01UH0822EJ0100 Rev.1.00
Jul 31, 2019
b5
b4
b3
b2
1
1
1
1
b5
b4
b3
b2
1
1
1
1
23. Serial Communications Interface (SCIg, SCIh)
b1
b0
1
1
b1
b0
1
1
Page 635 of 1041

Advertisement

Table of Contents
loading

Table of Contents