Basic Mode Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
B M C
ASIC ODE
To activate the Basic mode, simply log in to the unit. After connecting the unit to a VT100 terminal (or
terminal emulator) and activating a terminal session, the following prompt displays:
>
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 73
All other commands for this command set are described in this section in alphabetical order.
enable on page 37
logout on page 38
ping on page 39
ping ethernet on page 43
ping ipv6 on page 46
ping stack-member <number> on page 49
ping twamp on page 50
show clock on page 53
show snmp on page 54
show version on page 55
telnet <ip address> on page 56
traceroute on page 58
traceroute ethernet on page 60
traceroute ipv6 on page 63
60000CRG0-35E
S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Basic Mode Command Set

36