ADTRAN AOS Version R10.1.0 Command Reference Manual page 75

Command Reference Guide
interface t1 <slot/port>
interface t3 <slot/port>
interface tunnel <interface id> gre ip
interface vlan <interface id>
Syntax Description
adsl <slot/port>
atm <port | port.sublink>
bri <slot/port>
bvi <interface id>
cellular <slot/port>
dds <slot/port>
demand <interface id>
dot11ap <ap | ap/radio | ap/radio.vap> Identifies wireless access point, radio, and/or virtual access point
ap-type nv150
radio-type [802.11a | 802.11bg]
e1 <slot/port>
ethernet <slot/port>
fdl <slot/port>
frame-relay <port | port.sublink>
60000CRG0-35E
Identifies asymmetric digital subscriber line (ADSL) interfaces.
Slot and port number ranges are dependent upon the hardware
installed in the unit. Type interface adsl ? for information
regarding valid ranges.
Identifies and creates asynchronous transfer mode (ATM) virtual
interfaces or subinterfaces. Port number range is 1 to 1024.
Sublink number range is 1 to 65535.
Identifies basic rate interfaces (BRIs). Slot and port number
ranges are dependent upon the hardware installed in the unit.
Type interface bri ? for information regarding valid ranges.
Identifies bridged virtual interfaces (BVIs). This ID must
correspond to an existing bridge group. Valid range is 1 to 255.
Identifies cellular interfaces. Slot numbers are either 0 or 1. Port
numbers begin at 1 with a range dependent on the unit.
Identifies digital data service (DDS) interfaces. Slot and port
number ranges are dependent upon the hardware installed in the
unit. Type interface dds ? for information regarding valid ranges.
Identifies and creates demand routing interfaces. Valid range is
1 to 1024.
(VAP) interfaces. The AP number range is 1 to 8. The radio is
either 1 or 2. The VAP number range is 1 to 8.
Specifies the wireless access point (AP) type. Valid interface type
is nv150.
Specifies the radio interface type. Valid interface types are
802.11a and 802.11bg.
Identifies E1 interfaces. Slot and port number ranges are
dependent upon the hardware installed in the unit. Type interface
e1 ? for information regarding valid ranges.
Identifies Ethernet interfaces. Slot and port number ranges are
dependent upon the hardware installed in the unit. Type interface
ethernet ? for information regarding valid ranges.
Identifies facility data link (FDL) interfaces. Slot and port number
ranges are dependent upon the hardware installed in the unit.
Type interface fdl ? for information regarding valid ranges.
Identifies and creates Frame Relay interfaces. Port number range
is 1 to 1024. Sublink range is 1 to 1007.
Copyright © 2012 ADTRAN, Inc.
Common Commands
75