ADTRAN AOS Version R10.1.0 Command Reference Manual page 70

Command Reference Guide
description <text>
Use the description command to identify the specified interface (for example, circuit ID, contact
information, etc.). Use the no form of this command to remove a description.
Syntax Description
<text>
Default Values
No default values are necessary for this command.
Applicable Command Modes
Applies to all interface mode command sets.
Command History
Release 1.1
Usage Examples
The following example enters comment information using the description command:
(config)#interface t1 1/1
(config-t1 1/1)#description This is the Dallas office T1
60000CRG0-35E
Identifies the specified interface using up to 80 alphanumeric characters.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Common Commands
70