ADTRAN AOS Version R10.1.0 Command Reference Manual page 67

Command Reference Guide
cross-connect
Use the cross-connect command to create a cross-connection between a created time division multiplexing
(TDM) group on an interface to a virtual interface, or to create a cross-connection between a Point-to-Point
Protocol (PPP) interface and a Frame Relay interface for use with PPP over Frame Relay (PPPoFR).
Variations of this command include:
cross-connect <number> <from interface> <to interface>
cross-connect <number> <from interface> <group number> <to interface>
Changing cross-connect settings could potentially result in service interruption.
Syntax Description
<number>
<from interface>
<group number>
<to interface>
Default Values
By default, there are no configured cross connections.
Applicable Command Modes
Applies to all interface mode command sets.
Command History
Release 1.1
Release 5.1
Release 17.7
Release A4.01
60000CRG0-35E
Identifies the cross connection using a number descriptor or label (useful in
systems that allow multiple cross connections). Valid range is 1 to 1024.
Specifies the interface (physical or virtual) on one end of the cross connection.
Specify an interface in the format <interface type [slot/port | slot/port.subinterface
id | interface id | interface id.subinterface id]>. For example, for a T1 interface, use
t1 0/1; for an Ethernet subinterface, use eth 0/1.1; and for an ATM subinterface,
use atm 1.1. Type cross-connect 1 ? for a list of valid interfaces.
Optional. Specifies which configured TDM group to use for this cross connection.
This subcommand only applies to T1 physical interfaces.
Specifies the virtual interface on the other end of the cross connection. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id]>. For example, for a T1 interface, use
t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1;
and for an ATM subinterface, use atm 1.1. Use the ? to display a list of valid
interfaces.
Command was introduced.
Command was expanded to include the E1 interface.
Command was expanded to include its use with the PPPoFR feature.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Common Commands
67