ADTRAN AOS Version R10.1.0 Command Reference Manual page 77

Command Reference Guide
t3 <slot/port>
tunnel <interface id> gre ip
vlan <interface id>
Default Values
By default, an interface is inactive. To activate the interface, enter the no shutdown command from within
the specific interface command set; for example, (config-ppp 7)#no shutdown. There are no default
values for these commands.
Command History
Release 1.1
Release 3.1
Release 8.1
Release 9.1
Release 11.1
Release 15.1
Release 17.2
Release A4.01
Release 18.1
Release R10.1.0
Functional Notes
When identifying a physical interface slot and port, keep the following in mind:
• Built-in nonremovable interfaces are identified by slot 0.
• Removable interfaces are identified by the physical labels on the slots.
• Interfaces are numbered per slot, from left to right, starting with 1.
60000CRG0-35E
Identifies T3 interfaces. Slot and port number ranges are
dependent upon the hardware installed in the unit. Type interface
t3 ? for information regarding valid ranges.
Identifies and creates Internet Protocol version 4 (IPv4) generic
routing encapsulation (GRE) tunnel interfaces. Valid range is 1 to
1024.
Identifies and creates virtual local area network (VLAN) interfaces.
Valid range is 1 to 4094.
Command was introduced.
Command was expanded to include the loopback interface.
Command was expanded to include the asynchronous transfer
mode (ATM) interface.
Command was expanded to include the high level data link control
(HDLC) interface.
Command was expanded to include demand, foreign exchange
office (FXO), and primary rate interface (PRI) interfaces.
Command was expanded to allow navigation from one interface to
another without exiting the current configuration mode. Also,
expanded to include access point (AP), radio, virtual access point
(VAP), and bridged virtual interface (BVI) interfaces.
Command was expanded to include cellular interface.
Command was expanded to include the Metro Ethernet Forum
(MEF) Metro Ethernet interface.
Command was expanded to include the ap-type and radio-type
parameters.
The tunnel <interface id> command was changed to tunnel
<interface id> gre ip.
Copyright © 2012 ADTRAN, Inc.
Common Commands
77