Table of Contents
Advertisement
Command Reference Guide
ipv6 dhcp pool <name>
Use the ipv6 dhcp pool command to create a Dynamic Host Control Protocol version 6 (DHCPv6) server
address pool and enter the pool's configuration mode. The server pool is used to define the information to
be assigned to DHCPv6 clients by the DHCPv6 server. The pool chosen to serve a specific client's request
is determined by the current pool selection algorithm, just as in DHCP version 4 (DHCPv4). Use the no
form of this command to remove the DHCPv6 server pool from the AOS unit's configuration. Refer to the
DHCPv6 Pool Command Set on page 3067
Syntax Description
<name>
Default Values
By default, no DHCPv6 server pools are configured.
Command History
Release 18.3
Functional Notes
Use the ipv6 dhcp pool command to create multiple DHCPv6 server address pools for various segments
of the network. Multiple address pools can be created to service different segments of the network with
tailored configurations.
Usage Examples
The following example creates the DHCPv6 server address pool (labeled Pool1) and enters the DHCPv6
pool's configuration mode:
(config)#ipv6 dhcp pool Pool1
(config-dhcpv6)#
60000CRG0-35E
for more information.
Specifies the name of the DHCPv6 pool using an alphanumeric string (up to
32 characters in length).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1192
Advertisement
Table of Contents
