ADTRAN AOS Version R10.1.0 Command Reference Manual page 1190

Command Reference Guide
ipv6 dhcp ping packets <number>
Use the ipv6 dhcp ping packets command to configure the number of ping packets transmitted by the
Dynamic Host Control Protocol version 6 (DHCPv6) server when testing an Internet Protocol version 6
(IPv6) address before it is assigned to a client. Use the no form of this command to prevent the DHCPv6
server from using ping packets as part of the IPv6 address assignment process.
Syntax Description
<number>
Default Values
By default, 2 ping packets are sent to test IPv6 addresses before assigning them to a DHCPv6 client.
Command History
Release R10.1.0
Usage Examples
The following example specifies that 8 ping packets are used by DHCPv6 to test IPv6 addresses before
assigning them to a client:
(config)#ipv6 dhcp ping packets 8
60000CRG0-35E
Specifies the number of DHCPv6 ping packets sent on the network before
assigning the IPv6 address to a requesting DHCPv6 client. Valid range is 0
to 100 packets.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1190