ADTRAN AOS Version R10.1.0 Command Reference Manual page 63

Command Reference Guide
traceroute ipv6
Use the traceroute ipv6 command to display the IPv6 nodes traversed to reach the specified destination.
Variations of this command include:
traceroute ipv6 <ipv6 address>
traceroute ipv6 <ipv6 address> <interface>
traceroute ipv6 <ipv6 address> <interface> source <ipv6 address>
traceroute ipv6 <ipv6 address> source <ipv6 address>
traceroute ipv6 vrf <name> <ipv6 address>
traceroute ipv6 vrf <name> <ipv6 address> <interface>
traceroute ipv6 vrf <name> <ipv6 address> <interface> source <ipv6 address>
traceroute ipv6 vrf <name> <ipv6 address> source <ipv6 address>
Syntax Description
<interface>
<ipv6 address>
source <ipv6 address>
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 18.1
Functional Notes
The traceroute ipv6 command can be issued from both the Basic and Enable modes.
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
platforms supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance
regardless of whether multi-VRF is configured. Therefore, executing the abovementioned commands
without specifying a VRF will only affect the default unnamed VRF.
60000CRG0-35E
Optional. Specifies the egress interface when tracing a route to an IPv6
link-local address (any address that has the prefix FE80::/64). Interfaces
are specified in the <interface type> <slot/port | interface id> format. For
example, for an Ethernet interface, use eth 0/1. Type traceroute ipv6 <ipv6
address> ? to display a list of valid interfaces. This variable is ignored when
using a non-link-local address.
Specifies the IPv6 address of the remote system's route to trace. IPv6
addresses should be expressed in colon hexadecimal format (X:X:X:X::X).
For example, 2001:DB8:1::1. Entering the traceroute ipv6 command using
a link-local destination address prompts the user for an egress interface.
Optional. Specifies the IPv6 address to use as the source address in the
probing packets. The source IPv6 address must be a valid address local to
the router on the specified VPN routing and forwarding (VRF) instance.
Optional. Specifies the VRF where the IPv6 address exists.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Basic Mode Command Set
63