ADTRAN AOS Version R10.1.0 Command Reference Manual page 58

Command Reference Guide
traceroute
Use the traceroute command to display the Internet Protocol version 4 (IPv4) routes a packet takes to
reach the specified destination. Variations of this command include:
traceroute
traceroute [ip] <ipv4 address | hostname>
traceroute [ip] <ipv4 address | hostname> <interface>
traceroute [ip] <ipv4 address | hostname> source <ipv4 address>
traceroute [ip] <ipv4 address | hostname> <interface> source <ipv4 address>
traceroute [ip] vrf <name> <ipv4 address | hostname>
traceroute [ip] vrf <name> <ipv4 address | hostname> <interface>
traceroute [ip] vrf <name> <ipv4 address | hostname> source <ipv4 address>
traceroute [ip] vrf <name> <ipv4 address | hostname> <interface> source <ipv4 address>
Syntax Description
ip
<interface>
<ipv4 address | hostname>
source <ipv4 address>
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 16.1
Release 18.3
Functional Notes
The traceroute command can be issued from both the Basic and Enable modes.
60000CRG0-35E
Optional. Specifies an IPv4 trace.
Optional. Specifies the egress interface to use for the trace. Interfaces are
specified in the <interface type> <slot/port | interface id> format. For
example, for an Ethernet interface, use eth 0/1. Type traceroute <ipv4
address | hostname> ? to display a list of valid interfaces.
Optional. Specifies the IPv4 address or host name of the remote system's
route to trace.
Optional. Specifies the IPv4 address of the interface to use as the source of
the trace. IPv4 addresses should be expressed in dotted decimal notation
(for example, 10.10.10.1).
Optional. Specifies the VPN routing and forwarding (VRF) where the route
exists.
Command was introduced.
Command was expanded to include the vrf parameter.
Command was expanded to include the <interface> and ip parameters.
Copyright © 2012 ADTRAN, Inc.
Basic Mode Command Set
58