ADTRAN AOS Version R10.1.0 Command Reference Manual page 44

Command Reference Guide
drop-eligible
interface <interface>
mep <mep id>
priority <priority>
repeat <number>
size <bytes>
timeout <timeout>
validate-data
verbose
wait <interval>
Default Values
By default, the count value is set to 5.
By default, the data pattern is set to abcd.
By default, the drop-eligible value is not set.
By default, the interval is set to 1000 milliseconds.
By default, the priority value is the priority specified in the MEP's configuration.
By default, the size value is set to 2 bytes.
By default, the timeout value is set to 2 seconds.
By default, the validate-data parameter is disabled.
Command History
Release 17.4
Release A4.01
60000CRG0-35E
Optional. Specifies the drop eligible bit value in the virtual local
area network (VLAN) tag.
Optional. Specifies the interface on which the transmitting MEP is
configured. Specify an interface in the format <interface type
[slot/port | slot/port.subinterface id | interface id | interface
id.subinterface id]>. For example, for an Ethernet subinterface,
use eth 0/1.1. For a list of appropriate interfaces, enter interface
? at the prompt.
Specifies the MEP ID of the transmitting MEP. MEP ID range is 1
to 8191.
Optional. Specifies the 802.1 priority bits that are sent in the
loopback message. Range is 0 to 7.
Optional. Specifies the number of loopback messages to be sent.
Range is 1 to 1024.
Optional. Specifies the size of the loopback message. Size
ranges from 1 to 60 bytes.
Optional. Specifies the time that the MEP will wait for a response
to the loopback message. Range is 0 to 60 seconds.
Optional. Specifies whether or not the transmitting MEP validates
the contents of the data TLV in the received loopback messages.
Optional. Specifies that the results are in detailed, rather than
summary, format.
Optional. Specifies a minimum time to wait between sending
loopback messages. Valid range is 100 to 60000 milliseconds.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface and the wait and repeat parameters.
Copyright © 2012 ADTRAN, Inc.
Basic Mode Command Set
44