Table of Contents
Advertisement
Command Reference Guide
Basic Mode Command Set
enable
Use the enable command (at the Basic Command mode prompt) to enter the Enable Command mode. Use
the disable command to exit the Enable Command mode. Refer to
show arp on page 415
for more
information.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Command was introduced.
Functional Notes
The Enable Command mode provides access to operating and configuration parameters and should be
password protected to prevent unauthorized use. Use the enable password command (found in the
Global Configuration mode) to specify an Enable Command mode password. If the password is set,
access to the Enable Commands (and all other "privileged" commands) is only granted when the correct
password is entered. Refer to
enable password <password> on page 942
for more information.
Usage Examples
The following example enters the Enable Command mode and defines an Enable Command mode
password:
>enable
#configure terminal
(config)#enable password ADTRAN
At the next login, the following sequence must occur:
>enable
Password: ******
#
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
37
Advertisement
Table of Contents
Need help?
Do you have a question about the AOS Version R10.1.0 and is the answer not in the manual?
Questions and answers