Show Snmp - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show snmp

Use the show snmp command to display the system Simple Network Management Protocol (SNMP)
parameters and current status of SNMP communications.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Usage Examples
The following is an example output using the show snmp command for a system with SNMP disabled and
the default chassis and contact parameters:
>show snmp
Chassis: Chassis ID
Contact: Customer Service
0 Rx SNMP packets
0 Bad community names
0 Bad community uses
0 Bad versions
0 Silent drops
0 Proxy drops
0 ASN parse errors
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Basic Mode Command Set
54