ADTRAN AOS Version R10.1.0 Command Reference Manual page 1213

Command Reference Guide
ipv6 load-sharing
Use the ipv6 load-sharing command to allow parallel routes in the Internet Protocol version 6 (IPv6) route
table to be used to balance IPv6 traffic to a specific destination across up to six equal paths. When this
command is enabled, the IPv6 route table can use multiple best routes and alternate between them. When
this command is disabled, the IPv6 route table uses a single best route. Use the no form of this command to
disable IPv6 load sharing. Variations of this command include:
ipv6 load-sharing per-destination
ipv6 load-sharing per-packet
Syntax Description
per-destination
per-packet
Default Values
By default, IPv6 load sharing is disabled.
Command History
Release R10.1.0
Usage Examples
The following example enables IPv6 load sharing based on the source and destination of the IPv6 packets:
(config)#ipv6 load-sharing per-destination
60000CRG0-35E
Specifies that the route used to forward a packet is based on a hash of the
source and destination IPv6 packet.
Specifies that each forwarding route lookup rotates through all the parallel
best routes.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1213