Table of Contents
Advertisement
Command Reference Guide
ipv6 firewall policy-log threshold <value>
Use the ipv6 firewall policy-log threshold command to specify the number of Internet Protocol version 6
(IPv6) access control policy (ACP) events identified by AOS before generating a log message. Use the no
form of this command to return to the default value. Variations of this command include:
ipv6 firewall policy-log threshold <value>
ipv6 firewall vrf <name> policy-log threshold <value>
The AOS IPv6 firewall must be enabled (using the command
for the stateful inspection firewall to be activated.
Syntax Description
<value>
vrf <name>
Default Values
By default, a log is generated after 100 policy events have been identified.
Command History
Release 18.1
Usage Examples
The following example specifies that a log is generated when 150 IPv6 ACP events are detected on the
default VRF:
(config)#ipv6 firewall policy-log threshold 150
60000CRG0-35E
Specifies the number of IPv6 policy events AOS identifies before creating
the log. Valid range is 1 to 4294967295.
Optional. Specifies a VPN routing and forwarding (VRF) instance for AOS to
monitor. If no VRF is specified, the default VRF is monitored.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
ipv6 firewall on page
1193)
1208
Advertisement
Table of Contents
