Table of Contents
Advertisement
Command Reference Guide
resource-utilization
Use the resource-utilization command to set a threshold limit for CPU or heap utilization notifications.
When the utilization threshold is surpassed, a resource trap is sent. Use the no form of this command to
remove the threshold setting. Variations of this command include:
resource-utilization cpu threshold <percentage> time-interval <value>
resource-utilization heap threshold <percentage>
Syntax Description
cpu
heap
threshold <percentage>
time-interval <value>
Default Values
By default, there are no thresholds configured.
Command History
Release A2.04
Functional Notes
Simple Network Management Protocol (SNMP) resource traps must be enabled before exceeded
threshold notifications are sent. Refer to
Usage Examples
The following example configures the CPU resource notification to be sent when the CPU usage maintains
at least 75 percent utilization for 40 seconds:
(config)#resource-utilization cpu threshold 75 time-interval 40
60000CRG0-35E
Sets the threshold for CPU utilization notification.
Sets the threshold for heap utilization notification.
Specifies the threshold limit as a percentage of resource utilization.
Valid range is 1 to 100 percent.
Specifies the time interval for the actual utilization to exceed the threshold
before a notification is sent. Valid range is 1 to 86400 seconds.
Command was introduced.
snmp-server enable traps on page
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1322.
1304
Advertisement
Table of Contents
