ADTRAN AOS Version R10.1.0 Command Reference Manual page 1336

Command Reference Guide
snmp-server user
Use the snmp-server user command to configure Simple Network Management Protocol (SNMP) users to
control access to SNMP information. Use the no form of this command to remove a user from the specified
SNMP group. Variations of this command include:
snmp-server user <username> <groupname> v1
snmp-server user <username> <groupname> v1 [ip access-class <ipv4 acl> | ipv6 access-class
<ipv6 acl>]
snmp-server user <username> <groupname> v2c
snmp-server user <username> <groupname> v2c [ip access-class <ipv4 acl> | ipv6 access-class
<ipv6 acl>]
snmp-server user <username> <groupname> v3
snmp-server user <username> <groupname> v3 [ip access-class <ipv4 acl> | ipv6 access-class
<ipv6 acl>]
snmp-server user <username> <groupname> v3 auth md5 <auth password> [ip access-class <ipv4
acl> | ipv6 access-class <ipv6 acl>]
snmp-server user <username> <groupname> v3 auth sha <auth password> [ip access-class <ipv4
acl> | ipv6 access-class <ipv6 acl>]
snmp-server user <username> <groupname> v3 priv des <priv password> [ip access-class <ipv4 acl>
| ipv6 access-class <ipv6 acl>]
snmp-server user <username> <groupname> remote <host> v3
snmp-server user <username> <groupname> remote <host> v3 [ip access-class <ipv4 acl> |
ipv6 access-class <ipv6 acl>]
snmp-server user <username> <groupname> remote <host> v3 auth md5 <auth password>
[ip access-class <ipv4 acl> | ipv6 access-class <ipv6 acl>]
snmp-server user <username> <groupname> remote <host> v3 auth sha <auth password>
[ip access-class <ipv4 acl> | ipv6 access-class <ipv6 acl>]
snmp-server user <username> <groupname> remote <host> v3 priv des <priv password>
[ip access-class <ipv4 acl> | ipv6 access-class <ipv6 acl>]
If service password-encryption is enabled, the running configuration changes to include
the keyword encrypted before each password entry, which is masked. Refer to the
command
Syntax Description
<username>
<groupname>
v1
v2c
v3
auth md5 <auth password> Uses the HMAC-MD5-96 authentication level and a password string to
auth sha <auth password>
60000CRG0-35E
service password-encryption on page
Specifies the name of the user.
Specifies the name of the group the user belongs to.
Uses SNMP version 1 security model.
Uses SNMP version 2c security model.
Uses SNMP version 3 (user-based security model).
build the key for the authentication level.
Uses the HMAC-SHA-96 authentication level and a password string to
build the key for the authentication level.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1315.
1336