ADTRAN AOS Version R10.1.0 Command Reference Manual page 1218

Command Reference Guide
ipv6 policy-timeout
Use multiple ipv6 policy-timeout commands to customize policy timeout intervals for established Internet
Protocol version 6 (IPv6) firewall sessions. The policy session timeout determines when the time to live
(TTL) for the session expires and ends the session. This command configures the policy timeout for the
following protocols: (Transmission Control Protocol (TCP), User Datagram Protocol (UDP), Internet
Control Message Protocol version 6 (ICMPv6), Authentication Header (AH) Protocol, generic routing
encapsulation (GRE), encapsulating security payload (ESP)) or specific services (by listing the particular
port number). Use the no form of this command to return to the default timeout values. Variations of this
command include:
ipv6 policy-timeout [vrf <name>] match <ipv6 acl name> [policy <ipv6 acp name>] <timeout>
ipv6 policy-timeout [vrf <name>] [all-protocols | ahp | esp | gre | icmpv6 | tcp | udp | <protocol
number>] [policy <ipv6 acp name>] <timeout>
ipv6 policy-timeout [vrf <name>] [tcp | udp] all-ports [policy <ipv6 acp name>] <timeout>
ipv6 policy-timeout [vrf <name>] [tcp | udp] <port> [policy <ipv6 acp name>] <timeout>
ipv6 policy-timeout [vrf <name>] [tcp | udp] range <beginning port> <ending port> [policy <ipv6 acp
name>] <timeout>
Syntax Description
<timeout>
match <ipv6 acl name>
policy <ipv6 acp name>
ahp
esp
gre
icmpv6
all-protocols
60000CRG0-35E
Specifies the wait interval (in seconds) before an active session is
closed. Valid range is 1 to 4294967295 seconds.
Specifies that if traffic creating the policy session matches the specified
IPv6 access control list (ACL), the policy timeout value set using this
command is used for the policy session. Because an ACL can be used
to specify protocol and port information, you do not need to specify
ports or protocols when using this version of the command. If the
named ACL does not exist when this command is issued, an implicit
ACL is created.
Optional. Specifies that if the policy session uses the specified IPv6
access control policy (ACP) as its ingress policy class, the policy
timeout value set using this command is used for the policy session
(provided the ACL or protocol/port information matches if specified). If
the named ACP does not exist when this command is issued, an
implicit ACP is created.
Specifies the data protocol as AHP.
Specifies the data protocol as ESP.
Specifies the data protocol as GRE.
Specifies the data protocol as ICMPv6.
Specifies the timeout for all protocols. This policy session timeout is
used when a specific protocol match is not found.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1218