Table of Contents
Advertisement
Command Reference Guide
monitor session <number>
Use the monitor session command to configure a port mirroring session. Use the no form of this command
to remove a port mirroring session or to remove a source or destination interface. Variations of this
command include:
monitor session <number> destination interface <interface> no-isolate
monitor session <number> destination interface <interface> no-tag
monitor session <number> destination interface <interface> no-isolate no-tag
monitor session <number> destination interface <interface> no-tag no-isolate
monitor session <number> source interface <interface>
monitor session <number> source interface <interface> both
monitor session <number> source interface <interface> rx
monitor session <number> source interface <interface> tx
Syntax Description
<number>
destination
source
interface <interface>
both
rx
tx
no-tag
no-isolate
Default Values
By default, traffic is monitored in both directions. Also by default, the destination port is isolated from
passing native traffic.
Command History
Release 5.1
Release 13.1
60000CRG0-35E
Selects the monitor session number (only one is allowed).
Selects the destination interface.
Selects the source interface(s). A range of interfaces is allowed.
Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type monitor session <number> [destination | source]
interface ? for a complete list of valid interfaces.
Optional. Monitors both transmitted and received traffic.
Optional. Monitors received traffic only.
Optional. Monitors transmitted traffic only.
Removes the virtual local area network (VLAN) tag that is normally
appended to mirrored traffic.
Allows native traffic to continue to pass on the port set as the mirroring
session destination.
Command was introduced.
Command was expanded to include the no-isolate parameter.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1268
Advertisement
Table of Contents
