ADTRAN AOS Version R10.1.0 Command Reference Manual page 1322

Command Reference Guide
snmp-server enable traps
Use the snmp-server enable traps command to enable all Simple Network Management Protocol
(SNMP) traps available on your system. Use the no form of this command to disable SNMP traps.
Variations of this command include:
snmp-server enable traps
snmp-server enable traps bgp
snmp-server enable traps frame-relay
snmp-server enable traps resource
snmp-server enable traps snmp
snmp-server enable traps track
snmp-server enable traps voice
Syntax Description
bgp
frame-relay
resource
snmp
track
voice
Default Values
By default, there are no traps enabled.
Command History
Release 1.1
Release 17.3
Release 17.6
Release A2.04
Release 18.1
Functional Notes
Resource utilization traps are configured by using the command
60000CRG0-35E
Optional. Enables the Border Gateway Protocol (BGP) traps.
Optional. Enables the Frame Relay notification traps.
Optional. Enables the resource utilization notification traps. This option is
only available on AOS voice products.
Optional. Enables the SNMP notification traps.
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Optional. Enables the network monitor track traps.
Optional. Enables voice notification traps.
Command was introduced.
Command was expanded to include the Frame Relay.
Command was expanded to include voice traps.
Command was expanded to include resource traps.
Command was expanded to include bgp and track traps.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
resource-utilization on page 1304.
1322