ADTRAN AOS Version R10.1.0 Command Reference Manual page 1258

Command Reference Guide
ACL criteria are compared to the incoming frame in the order in which they were entered or from the top of
the list down. Generally, the most specific entries should be at the top and the more general at the bottom.
Changing hardware ACL or hardware access map configuration or application causes
new information to be reinstalled on the hardware. It is possible to run out of hardware
resources depending on how many resources are needed to apply the desired change. If
there are not enough hardware resources to install the new criteria in the hardware, an
error message is displayed. You can view the amount of hardware resources available
using the command
60000CRG0-35E
show hw-filter-resource on page
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
518.
1258