ADTRAN AOS Version R10.1.0 Command Reference Manual page 1291

Command Reference Guide
probe
Use the probe command to create a probe as part of network monitoring. This command is also used to
enter into the Network Monitoring Probe command set once a probe is created. A probe can be one of five
types: http-request, icmp-echo, icmp-timestamp, tcp-connect, or twamp. Each probe type has a set of
commands used for configuration. These additional commands are covered in
Command Set on page
command include:
probe <name> http-request
probe <name> icmp-echo
probe <name> icmp-timestamp
probe <name> tcp-connect
probe <name> twamp
Issue the no shutdown command to activate the probe once it is configured.
The probe is not operational until tolerance is defined. Refer to
Command Set on page 2938
Syntax Description
<name>
http-request
icmp-echo
icmp-timestamp
tcp-connect
twamp
Default Values
By default, there are no probes configured.
60000CRG0-35E
2938. Use the no form of this command to delete the probe. Variations of this
for more information.
Specifies the name of the probe being created, or indicates the probe
affected by the commands that follow.
Specifies the probe type being created as an Hypertext Transfer Protocol
(HTTP) request.
Specifies the probe type being created as an Internet Control Message
Protocol (ICMP) echo.
Specifies the probe type being created as an ICMP timestamp.
Specifies the probe type being created as a Transmission Control Protocol
(TCP) connect.
Specifies the probe type being created as a Two-Way Active Measurement
Protocol (TWAMP).
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
Network Monitor Probe
Network Monitor Probe
1291