ADTRAN AOS Version R10.1.0 Command Reference Manual page 1270

Command Reference Guide
name-server
Use the name-server command to designate an address for one or more name servers to use for
name-to-address domain naming server (DNS) resolution. This command can be applied to the default
virtual private network (VPN) routing and forwarding (VRF) instance or a specific VRF instance. Use the
no form of this command to remove an address. Variations of this command include:
name-server <ipv4 address>
name-server <ipv6 address>
name-server vrf <name> <ipv4 address>
name-server vrf <name> <ipv6 address>
Syntax Description
<ipv4 address>
<ipv6 address>
vrf <name>
Default Values
By default, no name servers are specified.
Command History
Release 3.1
Release 16.1
Release 18.3
Release R10.1.0
Functional Notes
The addition of the server address occurs at the end of the IPv4 or IPv6 addresses in the server list. There
is no limit to the number of name server addresses that can be entered. Addresses added using this
command are combined with those learned dynamically, and if an IPv6 DNS name server is added, its
address is combined with those configured using IPv4 DNS.
60000CRG0-35E
Specifies an Internet Protocol version 4 (IPv4) name server address. IPv4
addresses should be specified in dotted decimal notation (for example,
10.10.10.1).
Specifies an Internet Protocol version 6 (IPv6) name server address. IPv6
address should be expressed in colon hexadecimal format (X:X:X:X::X).
For example, 2001:DB8:1::1.
Optional. Specifies a nondefault VRF instance on which to add a name
server address. If no VRF instance is specified, the name server is added
on the default VRF instance.
Command was introduced.
Command was expanded to include the vrf parameter.
Command was expanded to include IPv6 support for ADTRAN
internetworking products.
Command was expanded to include IPv6 support for ADTRAN voice
products.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1270