Table of Contents
Advertisement
Command Reference Guide
ntp source <interface>
Use the ntp source command to specify the source interface for the Network Time Protocol (NTP)
packets. Use the no form of this command to return to the default setting.
Syntax Description
<interface>
Default Values
By default, the NTP source interface is not set.
Command History
Release 17.2
Release A4.01
Release A5.01
Usage Examples
The following example defines NTP source interface as ppp 1:
(config)#ntp source ppp 1
60000CRG0-35E
Specifies the source interface (physical or virtual) to use for the server.
Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; and for an ATM subinterface, use
atm 1.1. Enter ntp source ? for a list of valid interfaces.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1279
Advertisement
Table of Contents
