ADTRAN AOS Version R10.1.0 Command Reference Manual page 1309

Command Reference Guide
router pim-sparse
Use the router pim-sparse command to globally enable protocol-independent multicast (PIM) on the unit
and to enter the PIM Sparse Configuration mode. Use the no form of this command to disable PIM Sparse
routing. Refer to the Router (PIM Sparse) Command Set on page 3015
subcommands for PIM Sparse Configuration mode.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 11.1
Functional Notes
Additional commands for PIM are found in the related interface configuration modes. Refer to the
ip pim-sparse commands in sections such as
Relay Subinterface Command Set on page
Interface Command Set on page
Command Set on page
Usage Examples
The following example uses the router pim-sparse command to enter the PIM Sparse Configuration
mode:
(config)#router pim-sparse
(config-pim-sparse)#
60000CRG0-35E
Command was introduced.
Ethernet Interface Command Set on page
2193,
2389, PPP Interface Command Set on page
2588, and VLAN Interface Command Set on page 2704
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
for more information on the
HDLC Interface Command Set on page
1594, Frame
2308, Loopback
2463, Tunnel Interface
for more information.
1309