ADTRAN AOS Version R10.1.0 Command Reference Manual page 1292

Command Reference Guide
Command History
Release 13.1
Release 17.2
Usage Examples
The following example creates an ICMP echo probe called probe1:
>enable
#configure terminal
(config)#probe probe1 icmp-echo
(config-probe-probe1)#
Technology Review
Probes are standalone objects that help determine the status of a route based on the success or failure of
probe traffic across the path. The probes can be configured to trigger at particular intervals. There are
three types of probes supported by AOS: icmp-echo, tcp-connect, and http-request. Commands
common to all the probe types are identified in the following section, as well as isolated commands that
only apply to the specific probe types.
Additional configuration commands are available for associating tracks with each probe. These are
explained in the Network Monitor Track Command Set on page
60000CRG0-35E
Command was introduced.
Command was expanded to include the ICMP timestamp and TWAMP
probe types.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
2977.
1292