ADTRAN AOS Version R10.1.0 Command Reference Manual page 1329

Command Reference Guide
snmp-server host
Use the snmp-server host command to configure the host to receive Simple Network Management
Protocol (SNMP) notifications. Use the no form of this command to remove a specified host. Variations of
this command include the following:
snmp-server host <ip address> informs version 1 <community>
snmp-server host <ip address> informs version 1 <community> snmp
snmp-server host <ip address> informs version 2c <community>
snmp-server host <ip address> informs version 2c <community> snmp
snmp-server host <ip address> informs version 3 auth <community>
snmp-server host <ip address> informs version 3 auth <community> snmp
snmp-server host <ip address> informs version 3 noauth <community>
snmp-server host <ip address> informs version 3 noauth <community> snmp
snmp-server host <ip address> informs version 3 priv <community>
snmp-server host <ip address> informs version 3 priv <community> snmp
snmp-server host <ip address> traps <community>
snmp-server host <ip address> traps version 1 <community>
snmp-server host <ip address> traps version 1 <community> [bgp | frame-relay | snmp | track | voice]
snmp-server host <ip address> traps version 2c <community>
snmp-server host <ip address> traps version 2c <community> [bgp | frame-relay | snmp | track |
voice]
snmp-server host <ip address> traps version 3 auth <community>
snmp-server host <ip address> traps version 3 auth <community> [bgp | frame-relay | snmp | track |
voice]
snmp-server host <ip address> traps version 3 noauth <community>
snmp-server host <ip address> traps version 3 noauth <community> [bgp | frame-relay | snmp | track
| voice]
snmp-server host <ip address> traps version 3 priv <community> [bgp | frame-relay | snmp | track |
voice]
snmp-server host <ip address> traps version 3 priv [bgp | frame-relay | snmp | track | voice]
Syntax Description
<ip address>
informs
traps
60000CRG0-35E
Specifies the IP address of the SNMP host that receives the SNMP
information. IP addresses should be expressed in dotted decimal notation
(for example, 10.10.10.1).
Enables INFORM messages to this host.
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Enables traps to this host. If the version is not specified, version 1 is used.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1329