ADTRAN AOS Version R10.1.0 Command Reference Manual page 1307

Command Reference Guide
router bgp <value>
Use the router bgp command to enable BGP and enter the BGP Configuration mode. Refer to the
Command Set on page 2858
Gateway Border (BGP) routing.
Syntax Description
<value>
Default Values
By default, BGP is disabled.
Command History
Release 10.1
Release 18.1
Functional Notes
The AS number of the local system of which this BGP router is a member must always be entered with this
command, even when re-entering BGP Configuration mode after BGP has already been activated on the
router.
Usage Examples
The following example uses the router bgp command to enable BGP and enter the BGP Configuration
mode:
(config)#router bgp 100
(config-bgp)#
60000CRG0-35E
for more information. Use the no form of this command to disable Border
Specifies the AS number of the local system of which this BGP router is a
member. Range is 1 to 4294967295.
Command was introduced.
Command was altered to support 4-byte AS numbers (previously AOS only
supported 2-byte numbers).
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
BGP
1307