Table of Contents
Advertisement
Command Reference Guide
radius-server host
Use the radius-server host command to specify the parameters for a remote authentication dial-in user
service (RADIUS) server. Use the no form of this command to return to the default setting. Variations of
this command include:
radius-server host <hostname | ip address>
radius-server host <hostname | ip address> acct-port <port>
radius-server host <hostname | ip address> auth-port <port>
radius-server host <hostname | ip address> key <key>
radius-server host <hostname | ip address> retransmit <number>
radius-server host <hostname | ip address> timeout <value>
Each parameter after <hostname | ip address> specifies the characteristics of the
individual RADIUS server. Parameters can be entered in a single command line, in any
order, but each may only be used once.
Syntax Description
<hostname | ip address>
acct-port <port>
auth-port <port>
key <key>
retransmit <number>
timeout <value>
Default Values
By default, acct-port is set to 1813 and auth-port is set to 1812. By default, the key, retransmit and
timeout values are the values set by the command
60000CRG0-35E
Specifies the server to configure. IP addresses should be expressed in
dotted decimal notation (for example, 10.10.10.1). If a host name is used, a
domain naming system (DNS) server should be learned by the AOS device
using Dynamic Host Configuration Protocol (DHCP), Point-to-Point Protocol
(PPP), or specified in the Global Configuration mode with the command
name-server on page
1270.
Specifies the User Datagram Protocol (UDP) port used by the AAA
accounting server. Port range is 0 to 65535. This command is reserved for
future use as currently AOS does not allow RADIUS servers for use with
AAA accounting.
Specifies the UDP port used by the AAA authentication server. The port
range is 0 to 65535.
Specifies the encryption key used by the RADIUS server. This command
overrides the global RADIUS key setting (set with the command
radius-server on page
1300). This command must be entered last in the
command line because everything after the key parameter is read as the
new key.
Specifies the number of connection attempts made to the server. Attempt
range is 1 to 100.
Specifies the time to wait (in seconds) for this server to reply to requests.
Range is 1 to 1000 seconds.
radius-server on page
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1300.
1302
Advertisement
Table of Contents
