ADTRAN AOS Version R10.1.0 Command Reference Manual page 1345

Command Reference Guide Global Configuration Mode Command Set
spanning-tree edgeport default
Use the spanning-tree edgeport default command to configure all ports to be edgeports by default. Use
the no form of this command to disable the setting. This command is overridden by the spanning-tree
edgeport command configured in the interface configuration mode.
Syntax Description
No subcommands.
Default Values
Disabled by default.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example configures all interfaces running spanning tree to be edgeports by default:
(config)#spanning-tree edgeport default
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface ethernet 0/1
(config-eth 0/1)#spanning-tree edgeport disable
or
(config)#interface ethernet 0/1
(config-eth 0/1)#no spanning-tree edgeport
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 1345