ADTRAN AOS Version R10.1.0 Command Reference Manual page 16

Command Reference Guide
Wireless Interface Command Sets
The wireless interface is similar to both the physical and virtual interfaces in function, except that it deals
with your wireless network. Wireless interfaces allow the configuration of wireless access points (APs),
access point radios, and virtual access points (VAPs).
The following table gives an example of the wireless interface command set. For more information on
wireless interfaces, refer to
Command Set Accessed By...
Wireless Specifying a wireless
Interface interface at the Global
Configuration mode prompt
as follows:
>enable
#config
(config)#interface dot11ap 1
Routing Command Sets
The routing command sets for the product serve two functions. Routing commands not only address the
manner in which your unit routes and disseminates information, but they also provide an additional level of
security for your network. Routing commands include parameters, such as AS path list, community list,
and network monitoring, and they determine whether your unit routes via Routing Information Protocol
(RIP), open shortest path first (OSPF), or protocol-independent multicast (PIM) sparse.
The following table gives an example of the routing command sets. For a complete list of routing
commands, refer to the
Command Set Accessed By...
Routing Specifying which routing
parameter you wish to set at
the Global Configuration mode
prompt as follows:
>enable
#config
(config)#router ospf
60000CRG0-35E
Command Descriptions on page
Command Descriptions on page
Copyright © 2012 ADTRAN, Inc.
23.
Sample Prompt With This Set You Can...
(config-dot11ap •
1)#
•
23.
Sample Prompt With This Set You Can...
(config-ospf)# •
•
Configuration Command Sets
Configure your unit's wireless
parameters (radios, APs, and
VAPs)
Configure how your wireless
network will integrate with your
wired network
Determine which devices are
compatible with your network
Determine how your unit
routes traffic and information
16