Command Reference Guide
Enable Mode
Enable mode is the mid-level tier in the command hierarchy, one step up from the Basic mode. ADTRAN
suggests that a password be required to access the Enable mode. Refer to the quick configuration guides
and quick start guides located online at
configuring a password.
From the Enable mode, you can access the configurations of your product, as well as handle how your unit
boots and runs, among other things. The following table describes the Enable mode.
Mode
Access By....
Enable
Entering enable while in the
Basic mode as follows:
>enable
For more information regarding the Enable command set, refer to the
83.
Global Mode
The Global mode is the highest level tier within AOS. The Global mode allows the user to make changes
regarding the entire product system. All of your system's configurations are accessed through the Global
mode. From this level, you can access not only line configurations, router configurations, and interface
configurations, but also any other configurations or parameters on your system. The following table
describes the Global mode.
Mode
Access By...
Global
Entering config while at the
Enable mode as follows:
>enable
#
#config
For more information on the Global mode, refer to
60000CRG0-35E
https://supportforums.adtran.com
Mode Prompt
#
Mode Prompt
(config)#
Global Configuration Mode Command Set on page
Copyright © 2012 ADTRAN, Inc.
Understanding Command Modes
for more information on
Accessible Commands
•
Manage the startup and running
configurations
•
Use the debug commands
•
Enter any of the configuration modes
Enable Mode Command Set on page
Accessible Commands
•
Set the system's Enable-level
password(s)
•
Configure the system global IP
parameters
•
Configure the SNMP parameters
•
Enter any of the configuration modes
852.
13