Command Description - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
Performing Common CLI Functions
The following table contains descriptions of common CLI commands.
Command
do
no shutdown
no
copy running-config
startup-config
show running config
debug
undebug all
The overhead associated with the debug command takes up a large portion of your AOS
product's resources, and at times can halt other processes. It is best to use the debug
command only during times when the network resources are in low demand (nonpeak
hours, weekends, etc.).
60000CRG0-35E
Description
The do command provides a way to execute commands in other command
sets without taking the time to exit the current command set. The following
example shows the do command used to view the Frame Relay interface
configuration while in the T1 interface command set:
(config)#interface t1 1/1
(config-t1 1/1)#do show interfaces fr 7
To activate an interface, enter no shutdown followed by the interface.
For example:
no shutdown t1 1/1
To undo an issued command or to disable a feature, enter no before the
command.
no debug voice
When you are ready to save the changes made to the configuration, enter this
command. This copies your changes to the unit's NVRAM. Once the save is
complete, the changes are retained even if the unit is shut down or suffers a
power outage.
Displays the current configuration.
Use the debug command to troubleshoot problems you may be experiencing
on your network. These commands provide additional information to help you
better interpret possible problems. For information on specific debug
commands, refer to the debug section beginning on
To turn off any active debug commands, enter this command.
Copyright © 2012 ADTRAN, Inc.
Performing Common CLI Functions
page 219.
21