ADTRAN AOS Version R10.1.0 Command Reference Manual page 17

Command Reference Guide
Security and Services Command Sets
The security and services command sets provide methods for you to configure additional security for your
unit, as well as determine the types of services you want your unit to perform. Included in these command
sets are quality of service (QoS) maps, Dynamic Host Configuration Protocol (DHCP) pools, and route
map configurations.
The following table includes an example of the security and services commands. For a more detailed
listing of the command sets, refer to
Command Accessed By...
Set
Security and Specifying the service you
Services would like to perform at the
Global Configuration mode
prompt as follows:
>enable
#config
(config)#aaa group server
radius myServer
Voice Group Command Sets
Voice group command sets deal with the configuration and organization of voice groups within your
network. The commands allow you to configure voice features as part of a collective group, and to define
how these groups behave.
The following table gives a small example of the voice group command sets. For a more detailed
description, refer to Command Descriptions on page
Command Set Accessed By...
Voice Groups Specifying the voice group you
would like to configure at the
Global Configuration mode
prompt as follows:
>enable
#config
(config)#voice ring-group
1234
60000CRG0-35E
Command Descriptions on page
Sample Prompt With This Set You Can...
(config-sg-radius)# •
23.
Sample Prompt With This Set You Can...
(config-1234)#
Copyright © 2012 ADTRAN, Inc.
Configuration Command Sets
23.
Map the quality of a variety of
services
• Set the parameters for the DHCP
• Configure the unit's route map
• Set parameters for ring groups,
operator groups, trunk groups,
paging groups, and more
• Specify the behaviors and
permissions of voice groups,
as well as define the members
of the groups
17