ADTRAN AOS Version R10.1.0 Command Reference Manual page 1358

Command Reference Guide
tacacs-server host
Use the tacacs-server host command to specify the parameters for a terminal access controller
access-control system plus (TACACS+) server. Use the no form of this command to return to the default
setting. Variations of this command include the following:
tacacs-server host <hostname> | <ip address>
tacacs-server host <hostname> | <ip address> key <key>
tacacs-server host <hostname> | <ip address> port <port>
tacacs-server host <hostname> | <ip address> timeout <value>
Each parameter after <hostname | ip address> specifies the characteristics of the
individual TACACS+ server. Parameters can be entered in a single command line, in any
order, but each may only be used once.
Syntax Description
<hostname> | <ip address>
key <key>
port <port>
timeout <value>
Default Values
By default, the TACACS+ server uses TCP port 49. By default, the key and timeout values are the values
set by the command tacacs-server on page
Command History
Release 11.1
Functional Notes
At a minimum, the address (IP or host name) of the server must be given. The other parameters can be
entered in any order (except the key parameter) and, if the parameters are not specified, they will take
default values or fall back on the global TACACS+ server's default settings (set using the command
tacacs-server on page
60000CRG0-35E
Specifies the server to configure. IP addresses should be expressed
in dotted decimal notation (for example, 10.10.10.1). If a host name is
used, a domain naming system (DNS) server should be learned by
the AOS device using Dynamic Host Configuration Protocol (DHCP),
Point-to-Point Protocol (PPP), or specified in the Global Configuration
mode with the command
Specifies the encryption key used by the TACACS+ server. This
command overrides the global TACACS+ key setting (set with the
command
entered last in the command line because everything after the key
parameter is read as the new key.
Specifies the Transmission Control Protocol (TCP) port used by the
TACACS+ server. Range is 1 to 65535.
Specifies the time to wait (in seconds) for the server to reply to
requests. Range is 1 to 1000 seconds.
1357.
Command was introduced.
1357).
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
name-server on page
tacacs-server on page 1357). This command must be
1270.
1358