ADTRAN AOS Version R10.1.0 Command Reference Manual page 1351

Command Reference Guide
spanning-tree priority <value>
Use the spanning-tree priority command to set the priority for spanning-tree interfaces. The lower the
priority value, the higher the likelihood the configured spanning-tree interface will be the root for the
bridge group. To return to the default bridge priority value, use the no form of this command.
Syntax Description
<value>
Default Values
By default, the priority level is set to 32768.
Command History
Release 5.1
Usage Examples
The following example sets spanning-tree priority to the maximum level:
(config)#spanning-tree priority 0
60000CRG0-35E
Sets a priority value for the bridge interface. Configuring this value to a low
number increases the interface's chance of being the root. Therefore, the
maximum priority level would be 0. Range is 0 to 65535.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1351