ADTRAN AOS Version R10.1.0 Command Reference Manual page 1357

Command Reference Guide
tacacs-server
Use the tacacs-server command to configure several terminal access controller access-control system plus
(TACACS+) parameters for all TACACS+ servers on the network. Most of these global settings can be
overridden on a per-server basis (using the command
this command to return to the default setting. Variations of this command include the following:
tacacs-server key <key>
tacacs-server packet maxsize <value>
tacacs-server timeout <value>
Syntax Description
key <key>
packet maxsize <value>
timeout <value>
Default Values
By default, there is no key specified for TACACS+ servers, the packet maxsize is set to 10240 kb, and the
TACACS+ server timeout is set to 5 seconds.
Command History
Release 11.1
Usage Examples
The following example sets a timeout limit of 60 seconds for all TACACS+ servers:
(config)#tacacs-server timeout 60
60000CRG0-35E
tacacs-server host on page
Specifies the encryption key used by all TACACS+ servers. This is a
global setting; however, it can be overridden on a per-server basis.
Specifies the maximum packet size that can be sent to any TACACS+
server. Packet maxsize range is 10240 to 65535 kilobytes.
Specifies the time (in seconds) that the AOS unit will wait for the
server's reply before declaring an error. The time range is 1 to 1000
seconds. This is a global setting; however, it can be overridden on a
per-server basis.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1358). Use the no form of
1357