Table of Contents
Advertisement
Command Reference Guide
voice timeouts
Use the voice timeouts command to configure the time limits for phases. Use the no form of this command
to return to the default setting or remove the named digit timeout (NDT) and its value.
When removing an NDT and its value, if the NDT is assigned to a dial plan entry, then the
deletion is not allowed. The dial plan must be removed first and added back into the system
without the NDT association.
Variations of this command include:
voice timeouts alerting <value>
voice timeouts connected <value>
voice timeouts interdigit <value>
voice timeouts named-digit-timeout <ndt name>
voice timeouts named-digit-timeout <ndt name> <value>
Syntax Description
alerting <value>
connected <value>
interdigit <value>
named-digit-timeout
<ndt name>
<ndt name> <value>
Default Values
By default, the alerting timeout is 5 minutes, the connected timeout is 12 hours, and the interdigit
timeout is 4 seconds. If no value is indicated for the NDT, 0 seconds is applied.
Command History
Release 14.1
Release A2
60000CRG0-35E
Specifies the maximum time a call is allowed to remain in the alerting state.
The shorter of this timeout or the configured maximum number of rings will
determine how long a call is allowed to ring. The valid range is 0 (unlimited)
to 60 minutes.
Specifies the maximum time a call is allowed to remain in the connected
state. The valid range is 0 (unlimited) to 1000 hours.
Specifies the maximum time allowed between dialed digits. The valid range
is 1 to 16 seconds.
Creates a timeout with a name and a value to associate with a dial plan
template.
Specifies the name of the named-digit-timeout to be created.
Optional. Indicates the timeout value in seconds to allow after the last digit
is dialed before routing the call. The valid range is 1 to 16 seconds.
Command was introduced.
Command was expanded to include the named-digit-timeouts.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1446
Advertisement
Table of Contents
