Table of Contents
Advertisement
Command Reference Guide
voice trunk <trunk id> type analog supervision
Use the voice trunk type analog supervision command to define a new trunk for an analog interface.
Executing this command activates the Voice Trunk Analog Configuration mode for the individual trunk.
Use the no form of this command to delete a configured voice trunk. Refer to
Command Set on page 3443
include the following:
voice trunk <trunk id> type analog supervision dpt
voice trunk <trunk id> type analog supervision ground-start
voice trunk <trunk id> type analog supervision loop-start
Syntax Description
<trunk id>
dpt
ground-start
loop-start
Default Values
No default values are necessary for this command.
Command History
Release 9.1
Usage Examples
The following example creates the new trunk T15 for use with an analog interface and enters the Voice
Trunk Analog DPT Configuration mode:
(config)#voice trunk t15 type analog supervision dpt
(config-T15)#
60000CRG0-35E
for information on the commands in that mode. Variations of this command
Specifies the trunk's two-digit identifier in the format Txx (for example, T01).
Specifies dial pulse terminate (DPT) with an assumed user role.
Specifies ground start (GS) with an assumed user role.
Specifies loop start (LS) with an assumed user role.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
Voice Analog Trunk
1453
Advertisement
Table of Contents
